Discussion in 'D.I.Y.' started by jakkalsbothma, Jun 30, 2015.
Got the idea from @GDT7
was a lot easier than I thought it would be...
Photos...or it didn't happen buddy
Just bent or moulded it round a pencil, much smaller than the inlet pipe, and just slipped it over, stays in place no problem...
Where did you get the mesh from?
I use it in my factory, it's a mechanical filter for the molten polymers in my extruders... you want some?
If you have spare...or buy in bulk...lemme know...I'll buy some
I buy them in punched circles...
Then just cut them with scissors into the width i need...
Welcome to swing round my place tomorrow AFTER the traffic and pick a few up, just let me know how many and what size...
that's such a good idea!
+1, think its a great idea!!
Thanks, but the credit has to go to @GDT78 - I just copied his idea...
Always buy in bulk, very compulsively... LOL (you should know...)
This looks awesome!
Plus nice slim.
Makes all the other guards seem big and bulky!
Dude I think you are going to be inundated with requests for those screens
hee hee, no problem, I got stock - lots, and i know where to get more...
Any1 in Cpt know where we could get som3 of these? @Trevpleco think you also mentioned these.
Looks great @jakkalsbothma.
You better think up a name ASAP.
i think its going to get clogged fast
Separate names with a comma.